Onicon System-30 BTU Bedienungsanleitung PDF herunterladen (Seite 10)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-30 BTU Measurement System Manual 05/14 - 0667-2 / 18335 Page 10

3.2 MECHANICAL INSTALLATION

3.2.1 Main Unit Installation

TYPICAL SYSTEM-30 INSTALLATION

CAUTION

Before you attempt to use the BTU measurement system, isolate the main unit, open the bypass

and ush the entire system so that it is free of ux, solder, pipe and tube cuttings and any other

free moving particles.

Installing the meter body

1. Make sure the unions are free of nicks or scratches on either end of the ow

meter body and on the process connections.

2. Spray the union faces with a silicone spray or apply a thin coat of beeswax to enhance

seating. Do not use paste thread sealant on union faces.

3. Orient the ow arrow on the meter with the direction of ow.

4. Recommended torques for union seal: 70 ft/lbs minimum

5. Make sure alignment of pipe does not put lateral stress on either joint.

Process

Connection

Process

Connection

Unions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Keine Kommentare

Onicon System-30 BTU Bedienungsanleitung Seite 10