Onicon D-100 P1 Bedienungsanleitung PDF herunterladen (Seite 6)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-100-P1 Flow Display Manual 05/14 - 0660-3 / 18343 Page 6

1.4 NETWORK SIGNAL CONNECTIONS

1.4.1 Standard Network Interface

P1 RS485, 2-wire (half duplex) serial output connections are connected to terminals as

shown. Do not exceed 4.4 in-lb (0.5Nm) of torque when tightening.

CAUTION

Only qualied service personnel should make connections between the D-100 and the user’s

external equipment. ONICON assumes no responsibility for damage caused to the external

equipment as a result of an improper installation.

CAUTION

Incoming and outgoing RS485 cable shield wires should be connected together, but must not be

connected to the D-100.

P1 (-)

P1 (+)

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Keine Kommentare

Onicon D-100 P1 Bedienungsanleitung Seite 6