Onicon System-10 P1 Bedienungsanleitung PDF herunterladen (Seite 5)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]

System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 5

SECTION 1.0: INTRODUCTION

1.1 PURPOSE OF THIS GUIDE

The purpose of this guide is to provide installation and commissioning procedures and basic

operating and servicing instructions for the ONICON SYSTEM-10 BTU Meter equipped with a

Siemens Floor Level Network Communications Driver and Point Database.

NOTE: Also refer to Siemens’ Application Note, Document No. 140-0280.

1.2 TYPICAL SYSTEM-10 BTU METER

ONICON’S System-10 is a true heat (BTU) computer, which accepts data from several sensors,

performs a series of computations with that data, and displays and/or transmits the results as an

indication of the amount of heat (BTU’s) being transferred per unit time or as a totalized amount.

1.3 STANDARD FEATURES AND SPECIFICATIONS

• Single mode BTU calculations, in either the heating or cooling mode, are totalized,

displayed and reported to the P1 network.

• Two-pipe dual mode BTU calculations in both the heating mode and the cooling mode are

totalized, displayed and reported separately to the P1 network.

• B-directional dual mode BTU calculations are totalized, displayed and reported separately

to the P1 network.

WARNING

Only qualied service personnel should attempt to install or service this product. Serious injury

may result from the improper unstallation or use of this product.

1 2 3 4 5 6 7 8 9 10 ... 66 67

Keine Kommentare

Onicon System-10 P1 Bedienungsanleitung Seite 5